Open Search

DC motors: Final testing procedures without a dynamometer

Publication date: 
March 1999
Chuck Yung, EASA Senior Technical Support Specialist
Type of media: 

EASA's Engineering and Technical Support Department has received many calls over the past few months concerning repairs on DC motors. Most callers have asked for tips on troubleshooting to make sure repairs are handled correctly. Prior to assembly, all windings should be tested for shorts, grounds and correct polarity. After a DC motor is assembled and ready to test run, a few simple checks will greatly reduce the chance of motor problems. The following procedures should be especially helpful to those shops that don't have a dynamometer.

DC motors
Motor testing